Horsepower Cabinet Saw

Delta 36-L31X-U50 X5 10-Inch Left Tilt 3 Horsepower Cabinet Saw with 50 Unifence, 2 Cast Iron Extension Wings, Table Board, and Legs, 230-Volt 1 Phase

The X5 is one of the finest pieces of machinery we’ve seen. It’s the left-tilt version of Delta’s magnificent Unisaw, and everything from the motor to the finely machined T-slots is of the highest standard. Take the motor, for example. It’s a 3 HP, single phase 230-volt with full-voltage starter. It flawlessly powers a positive-traction, three-belt V-drive that runs between two massive lifetime ball bearings for no–and we mean zero–vibration. The table is cast-iron, smooth as glass, along with two cast-iron extension wings and a beautifully laminated table supported by rock-solid, leveler-footed steel legs. Riding along the huge 76-by-27-inch table surface is a 50-inch Unifence guide with an adjustable flip-stop; if you’ve ever used one, you know the precision. It glides like it’s on air and locks down with not a hair’s breadth of error, even at its maximum 50 inches to the right of the blade. Even the arbor is a piece of perfection, precision-ground, stress-proofed and flange-faced after production. Inside this 600-pound saw’s cabinet is a clever slope that directs sawdust right to the 4-inch duct collector chute to eliminate clogging in the cabinet. Quality saws always have a T-slot for the miter gauge, and this one’s no exception, allowing you to extend Delta’s super-precise Auto-Set miter gauge far beyond the front edge without tip-out or instability on both sides of the 10-inch blade. The left-tilting arbor allows you a max cut of 2-1/8 inches at 45 degrees, putting big gorgeous bevels well within your reach. If it’s precision and power you’re after, this is the last saw you’ll ever buy.

• 10-inch left-tilt unisaw with a powerful 3 hp single phase 230V motor
• Integrated 50-inch Unifence guide has an adjustable flip-stop
• 2 cast-iron extension wings, standard insert, miter gage, motor cover and 4-inch dust connector
• Carbide-tipped 50T saw blade, laminated table board, adjustable steel support legs
• 76 by 27-inch table surface; weighs 526 pounds; 5-year limited warranty on machines, parts and accessories